The Evaluation And Properties Of Coatings For Super Alloys And Refractory Metals
DOWNLOAD
Download The Evaluation And Properties Of Coatings For Super Alloys And Refractory Metals PDF/ePub or read online books in Mobi eBooks. Click Download or Read Online button to get The Evaluation And Properties Of Coatings For Super Alloys And Refractory Metals book now. This website allows unlimited access to, at the time of writing, more than 1.5 million titles, including hundreds of thousands of titles in various foreign languages. If the content not found or just blank you must refresh this page
The Evaluation And Properties Of Coatings For Super Alloys And Refractory Metals
DOWNLOAD
Author :
language : en
Publisher:
Release Date : 1965
The Evaluation And Properties Of Coatings For Super Alloys And Refractory Metals written by and has been published by this book supported file pdf, txt, epub, kindle and other format this book has been release on 1965 with categories.
A State Of The Art Survey Of Methods Being Used For The Evaluation Of Coatings For Super Alloys And Refractory Metals
DOWNLOAD
Author : W. A. James
language : en
Publisher:
Release Date : 1965
A State Of The Art Survey Of Methods Being Used For The Evaluation Of Coatings For Super Alloys And Refractory Metals written by W. A. James and has been published by this book supported file pdf, txt, epub, kindle and other format this book has been release on 1965 with Alaşımlar categories.
The report is based on a survey conducted in 1964 in the NATO countries on behalf of the Structures and Materials Panel of AGARD. The Report describes evaluation methods that came to the author's attention during the survey, and gives some typical results by the methods. As much as possible, the report excludes reference to reports that normally are given restricted distribution, and includes references to literature that is freely available. The survey indicated that methods for the determination of physical and mechanical properties were relatively well defined, after provision was made for testing at high temperatures. By contrast, widely different methods were being used to determine resistance to corrosion, to erosion, to thermal shock and to thermal fatigue: the various methods are described in some detail. Usually one or more of oxidation resistance, resistance to erosion by hot gases and the effect of stress were evaluated simultaneously with resistance to thermal fatigue. The differences in evaluation procedures appeared to reflect differences in opinion concerning what was wanted from a test. This Report is the result of a NATO Survey of Techniques in several nations. (Author).
High Temperature Oxidation Resistant Coatings
DOWNLOAD
Author : National Research Council (U.S.). Committee on Coatings
language : en
Publisher: National Academies
Release Date : 1970
High Temperature Oxidation Resistant Coatings written by National Research Council (U.S.). Committee on Coatings and has been published by National Academies this book supported file pdf, txt, epub, kindle and other format this book has been release on 1970 with Technology & Engineering categories.
Barrier Coatings For Refractory Metals And Superalloys
DOWNLOAD
Author : CJ Larkin
language : en
Publisher:
Release Date : 2006
Barrier Coatings For Refractory Metals And Superalloys written by CJ Larkin and has been published by this book supported file pdf, txt, epub, kindle and other format this book has been release on 2006 with categories.
In the closed working fluid loop of the proposed Prometheus space nuclear power plant (SNPP), there is the potential for reaction of core and plant structural materials with gas phase impurities and gas phase transport of interstitial elements between superalloy and refractory metal alloy components during service. Primary concerns are surface oxidation, interstitial embrittlement of refractory metals and decarburization of superalloys. In parallel with kinetic investigations, this letter evaluates the ability of potential coatings to prevent or impede communication between reactor and plant components. Key coating requirements are identified and current technology coating materials are reviewed relative to these requirements. Candidate coatings are identified for future evaluation based on current knowledge of design parameters and anticipated environment. Coatings were identified for superalloys and refractory metals to provide diffusion barriers to interstitial transport and act as reactive barriers to potential oxidation. Due to their high stability at low oxygen potential, alumina formers are most promising for oxidation protection given the anticipated coolant gas chemistry. A sublayer of iridium is recommended to provide inherent diffusion resistance to interstitials. Based on specific base metal selection, a thin film substrate--coating interdiffusion barrier layer may be necessary to meet mission life.
Scientific And Technical Aerospace Reports
DOWNLOAD
Author :
language : en
Publisher:
Release Date : 1995
Scientific And Technical Aerospace Reports written by and has been published by this book supported file pdf, txt, epub, kindle and other format this book has been release on 1995 with Aeronautics categories.
Technical Abstract Bulletin
DOWNLOAD
Author :
language : en
Publisher:
Release Date :
Technical Abstract Bulletin written by and has been published by this book supported file pdf, txt, epub, kindle and other format this book has been release on with Science categories.
Machining Of Superalloys And Refractory Metals
DOWNLOAD
Author : C. T. Olofson
language : en
Publisher:
Release Date : 1961
Machining Of Superalloys And Refractory Metals written by C. T. Olofson and has been published by this book supported file pdf, txt, epub, kindle and other format this book has been release on 1961 with Heat resistant alloys categories.
Contents: Machining superalloys General information Effect of alloy condition on machinability Minimizing work-hardening tendencies of superalloys Turning and facing operations Milling operations Drilling operations Machining of refractory metals Tungsten Effect of surface contaminations on machine ability Molybdenum Effect of anisotropy, grain structure and prior work on machinability Tantalum and columbium Turning operations, milling operations Bibliography.
Review Of Recent Developments In The Technology Of Nickel Base And Cobalt Base Alloys
DOWNLOAD
Author : D. A. Roberts
language : en
Publisher:
Release Date : 1961
Review Of Recent Developments In The Technology Of Nickel Base And Cobalt Base Alloys written by D. A. Roberts and has been published by this book supported file pdf, txt, epub, kindle and other format this book has been release on 1961 with Cobalt alloys categories.
Coatings For The Protection Of Refractory Metals From Oxidation
DOWNLOAD
Author : Carol Alnoth Krier
language : en
Publisher:
Release Date : 1961
Coatings For The Protection Of Refractory Metals From Oxidation written by Carol Alnoth Krier and has been published by this book supported file pdf, txt, epub, kindle and other format this book has been release on 1961 with Heat resistant alloys categories.
Metallic And Ceramic Coatings
DOWNLOAD
Author : M. G. Hocking
language : en
Publisher: Longman Publishing Group
Release Date : 1989
Metallic And Ceramic Coatings written by M. G. Hocking and has been published by Longman Publishing Group this book supported file pdf, txt, epub, kindle and other format this book has been release on 1989 with Science categories.
Much of this book consists of a review of the subject, in amended form, which the authors were commissioned to write by the EEC. It should be useful to those in the fields of materials science, physics, mechanical engineering, chemical engineering, metallurgy and aerospace engineering.